A new garage door can modernize the exterior of your home and improve your home safety as well. Some retailers offer complete garage door installation services. However, sometimes, you will be required to repair the garage door in case of breakdown. Doing it yourself may save some extra cash. If you have in-depth skills, you can install your new garage door in a matter of days.
To successfully install the garage door safely and effectively, ensure all the necessary tools are available. Once this is done, follow all guidance and installation tips provided by the manufacturers.
You will need to have several mandatory tools and equipment as you prepare to install the garage door. Once you have all the necessary tools, it’s time to dive into the real task. Here are few steps to follow for a successful garage door installation.
Ease the Tension of Your Garage Door
The first step during garage door repair Sugar Land TX is to remove the springs. During this step, you need to exercise extreme caution to avoid unprecedented injuries. You don’t want that heavyweight to end up on your toes. Therefore, make it a habit to release the torsion spring’s tension before commencing your garage door repair.
To successfully remove the springs, you need to use the adjustable locking pliers to clamp the spring shaft and wedge the pliers against the door’s wall. When you do that, you will notice holes in the spring cone. The holes are used to loosen and tighten the spring. Use the string rod to loosen the screw that holds the winding cone.
Disconnect the Garage Door
At this point, you have released the tension of the garage door. What follows is to disconnect the door from the opener. It would be best if you also were vigilant when disconnecting your door. After all, your safety is paramount during any DIY activity.
How do you disconnect your door safely? Pull that red-colored handle. It is an emergency release handle. You will notice you’re moving in a vertical position to allow you lower and raise your garage door with ease. Start at the top and remove the hinges. After that, loosen the boots to separate the track and the panels.
Assemble the Sectional Door Panels
At step three, the real installation begins. You can now replace a few things here and there to reinforce the panels against blowing in the center, make holes, and use the screw to secure the bar to the panels. Attaché the hinges on each panel and attach axial support to the top and bottom panels. After that, you will now start to replace each new panel with the previous one and repeat the process to the end.
Install the Hinges and the Tracks
At this point, you are halfway through with your garage door installation. Attach the top hinge to the panel and place the axle into the hinges. Next, install the track and ensure wheels lie perfectly in the track. Lastly, secure the door cable to the hook on the panel axle support, then attach the bottom bracket to the wall.
After that, put together every single material that supports the spring. Attach them to the track, then use the door ceiling support, place the curved section of the track on the vertical piece pre-crafted. After doing that, you then attach the other side of the ceiling bracket. Line your horizontal and vertical tracks up, and then bold them together.
Finish Up Everything
You are almost done. The next step would be to connect the spring anchors to the springs. Attach the spring locking cone, bolt the two springs tightly to the header bracket.
Slide the torsion rod into the holes located in the side header brackets, and fix the pulleys to each end of this rod to install it.
Attach the cable from beneath to the pulley wheel to turn the wheel. Doing this will help you pull any taut over the pulley. Slide the wheel to the header bracket to tighten all parts. After that, you then fix a pair of locking pliers to the rod outside the bracket.
Lastly, follow your manufacturer’s manual on carrying out garage door repair Sugar Land TX to help determine how many turns are required to tighten the spring properly. Once the spring is tightened correctly, replace all bolts to lock the spring in place before removing the torsion rod’s pliers.
